Oklahoma to build a state-of-the-art coal-fired power plant?
CeltGal asked:
Oklahoma Gas & Electric is seeking pre-approval from the Oklahoma Corporation Commission to build a new generating unit in Red Rock Oklahoma at an estimated $1.8 billion to meet the demands of higher energy. Coal is one of the major contributors to global warming. What are other alternatives that states not located along the coastline can look at?
Oklahoma Gas & Electric is seeking pre-approval from the Oklahoma Corporation Commission to build a new generating unit in Red Rock Oklahoma at an estimated $1.8 billion to meet the demands of higher energy. Coal is one of the major contributors to global warming. What are other alternatives that states not located along the coastline can look at?
solar and wind power.
Solarpower, probably a real good thing in Oklahoma
Windpower
Biogas
Energycrops
The most important factor is still measure to reduce the load on the grid as a whole. I have no usage figures for Oklahoma but I assume there are alot of airconditioners, being a hot state and in the us(read lots of ac). Initiatives to replace electritricy driven ACs with solar powered ACs can do alot. There are several techniques for to accomplish this. Private citizens and the state can probably save alot of money and energy from this measure alone, remeber this is just an example, but as most western world governments I guess the state of Oklahoma “just dont think” that way. They want to meet a percived demand on the state grid and dont acknowledge that the demand can in itself be reduced.
Also a system with many small units, homes, buisnessess are much less vulnerable. If the coal plants malcuntions or if someone blows it up it will create huge problems with the grid. In the current paranoid political climate in the us the latter might be the winning argument.
cheers, Mattias
Power station
From Wikipedia, the free encyclopedia
(Redirected from Power plant)
Jump to: navigation, search
For other uses, see Power station (disambiguation).
Oil power plant in Iraq Energy Portal
A power station (also referred to as generating station or power plant) is a facility for the generation of electric power. ‘Power plant’ is also used to refer to the engine in ships, aircraft and other large vehicles. Some prefer to use the term energy center because it more accurately describes what the plants do, which is the conversion of other forms of energy, like chemical energy, gravitational potential energy or heat energy into electrical energy. However, power plant is the most common term in the U.S., while elsewhere power station and power plant are both widely used, power station prevailing in many Commonwealth countries and especially in the United Kingdom.
At the center of nearly all power stations is a generator, a rotating machine that converts mechanical energy into electrical energy by creating relative motion between a magnetic field and a conductor. The energy source harnessed to turn the generator varies widely. It depends chiefly on what fuels are easily available and the types of technology that the power company has access to.
Thermal power stations
GE H Frame, Downward exhaust, 2 way axial flow Steam turbine generatorsMain article: Thermal power station
In thermal power stations, mechanical power is produced by a heat engine, which transforms thermal energy, often from combustion of a fuel, into rotational energy. Most thermal power stations produce steam, and these are sometimes called steam power stations. About 86% of all electric power is generated by use of steam turbines.[citation needed] Not all thermal energy can be transformed to mechanical power, according to the second law of thermodynamics. Therefore, there is always heat lost to the environment. If this loss is employed as useful heat, for industrial processes or district heating, the power plant is referred to as a cogeneration power plant or CHP (combined heat-and-power) plant. In countries where district heating is common, there are dedicated heat plants called heat-only boiler stations. An important class of power stations in the Middle East uses byproduct heat for desalination of water.
Classification
CHP plant in Warsaw, Poland
Geothermal power station in the Philippines
Coal Power Station in Tampa FLThermal power plants are classified by the type of fuel and the type of prime mover installed.
By fuel
Nuclear power plants use a nuclear reactor’s heat to operate a steam turbine generator.
Fossil fuelled power plants may also use a steam turbine generator or in the case of natural gas fired plants may use a combustion turbine.
Geothermal power plants use steam extracted from hot underground rocks.
Renewable energy plants may be fuelled by waste from sugar cane, municipal solid waste, landfill methane, or other forms of biomass.
In integrated steel mills, blast furnace exhaust gas is a low-cost, although low-energy-density, fuel.
Waste heat from industrial processes is occasionally concentrated enough to use for power generation, usually in a steam boiler and turbine.
By prime mover
Steam turbine plants use the dynamic pressure generated by expanding steam to turn the blades of a turbine.
Gas turbine plants use the dynamic pressure from flowing gases to directly operate the turbine. Natural-gas fuelled turbine plants can start rapidly and so are used to supply “peak” energy during periods of high demand, though at higher cost than base-loaded plants.
Combined cycle plants have both a gas turbine fired by natural gas, and a steam boiler and steam turbine which use the exhaust gas from the gas turbine to produce electricity. This greatly increases the overall efficiency of the plant, and most new baseload power plants are combined cycle plants fired by natural gas.
Internal combustion Reciprocating engines are used to provide power for isolated communities and are frequently used for small cogeneration plants. Hospitals, office buildings, industrial plants, and other critical facilities also use them to provide backup power in case of a power outage. These are usually fuelled by diesel oil, heavy oil, natural gas and landfill gas.
Microturbines, Stirling engine and internal combustion reciprocating engines are low cost solutions for using opportunity fuels, such as landfill gas, digester gas from water treatment plants and waste gas from oil production.
Cooling towers
Coal power plant in China with a hyperbolic cooling towerBecause of the fundamental limits to thermodynamic efficiency of any heat engine, all thermal power plants produce waste heat as a byproduct of the useful electrical energy produced. Natural draft wet cooling towers at nuclear power plants and at some large thermal power plants are large hyperbolic chimney-like structures (as seen in the image at the left) that release the waste heat to the ambient atmosphere by the evaporation of water (lower left image).
A Marley mechanical induced-draft cooling towerHowever, the mechanical induced-draft or forced-draft wet cooling towers (as seen in the image to the right) in many large thermal power plants, petroleum refineries, petrochemical plants, geothermal, biomass and waste to energy plants use fans to provide air movement upward through downcoming water and are not hyperbolic chimney-like structures. The induced or forced-draft cooling towers are rectangular, box-like structures filled with a material that enhances the contacting of the upflowing air and the downflowing water.
“Evaporation of water” at Ratcliffe Power Plant, UKIn desert areas a dry cooling tower or radiator may be necessary, since the cost of make-up water for evaporative cooling would be prohibitive. These have lower efficiency and higher energy consumption in fans than a wet, evaporative cooling tower.
Where economically and environmentally possible, electric companies prefer to use cooling water from the ocean, or a lake or river, or a cooling pond, instead of a cooling tower. This type of cooling can save the cost of a cooling tower and may have lower energy costs for pumping cooling water through the plant’s heat exchangers. However, the waste heat can cause the temperature of the water to rise detectably. Power plants using natural bodies of water for cooling must be designed to prevent intake of organisms into the cooling cycle. A further environmental impact would be organisms that adapt to the warmer plant water and may be injured if the plant shuts down in cold weather.
Other sources of energy
Other power stations use the energy from wave or tidal motion, wind, sunlight or the energy of falling water, hydroelectricity. These types of energy sources are called renewable energy.
Hydroelectricity
Main article: Hydroelectricity
Hydroelectric dams impound a reservoir of water and release it through one or more water turbines to generate electricity.
Pumped storage
A pumped storage hydroelectric power plant is a net consumer of energy but decreases the price of electricity. Water is pumped to a high reservoir during the night when the demand, and price, for electricity is low. During hours of peak demand, when the price of electricity is high, the stored water is released to produce electric power. Some pumped storage plants are actually not net consumers of electricity because they release some of the water from the lower reservoir downstream, either continuously or in bursts.
Solar
Main article: Solar power
A control room of a modern power stationA solar photovoltaic power plant converts sunlight into electrical energy, which may need conversion to alternating current for transmission to users. This type of plant does not use rotating machines for energy conversion. Solar thermal electric plants are another type of solar power plant. They direct sunlight using either parabolic troughs or heliostats. Parabolic troughs direct sunlight onto a pipe containing a heat transfer fluid, such as oil, which is then used to boil water, which turns the generator. The central tower type of power plant uses hundreds or thousands of mirrors, depending on size, to direct sunlight onto a receiver on top of a tower. Again, the heat is used to produce steam to turn turbines. There is yet another type of solar thermal electric plant. The sunlight strikes the bottom of the pond, warming the lowest layer which is prevented from rising by a salt gradient. A Rankine cycle engine exploits the temperature difference in the layers to produce electricity. Not many solar thermal electric plants have been built. Most of them can be found in the Mojave Desert, although Sandia National Laboratory, Israel and Spain have also built a few plants.
Wind
Main article: Wind power
Wind turbines can be used to generate electricity in areas with strong, steady winds. Many different designs have been used in the past, but almost all modern turbines being produced today use the Dutch six-bladed, upwind design. Grid-connected wind turbines now being built are much larger than the units installed during the 1970s, and so produce power more cheaply and reliably than earlier models. With larger turbines (on the order of one megawatt), the blades move more slowly than older, smaller, units, which makes them less visually distracting and safer for airborne animals. However, the old turbines can still be seen at some wind farms, particularly at Altamont Pass and Tehachapi Pass.
Wind power, wind farming, there is only one major wind farm in Oklahoma that I know of. They should help homeowners to cut power use and put up wind turbines and solar panels at residence and in neighborhoods.
All of us should try to use less power whenever we can. If they go ahead with building a plant, I hope it is to replace an older less efficient one, and as a back-up source of power.
Live well, love deep and do good!